Citrix ADC SDX26000

The Citrix ADC SDX 26000 appliances are 2U appliances. These appliances have two 14-core processors and 256 GB of memory. The appliance has eight 50G and sixteen 25G network ports.

有关Citrix ADC硬件平台上支持的软件发布的信息，请参见Citrix ADC SDX硬件软件兼容性矩阵。

The following figure shows the front panel of the Citrix ADC SDX 26000 appliances.

图1. Citrix ADC SDX 26000，前面板

The Citrix ADC SDX 26000 appliances have the following ports:

• RS232串行控制台端口。
• 一个10/100/1000Base-T RJ45铜以太网LOM端口。使用此端口独立于Citrix ADC软件来远程监视和管理设备。
• Two 10/100/1000Base-T RJ45 copper Ethernet Management Ports, numbered 0/1 and 0/2. These ports are used to connect directly to the appliance for Citrix ADC administration functions.
• Eight 50G ports, numbered 50/1 to 50/8.
• sixteen 25G ports, numbered 25/1 through 25/16.

The following figure shows the back panel of the SDX 26000 appliances.

Figure 2. Citrix ADC SDX 26000, back panel

以下组件可在Citrix ADC SDX 26000电器的后面板上看到：

• 两个240 GB和六个960 GB可移动固态驱动器（SSD）。

  笔记：随着组件变为EOL，驱动密度可能会增加，但其尺寸永远不会小于原始的。

• 电源开关，将电源转换为设备打开或关闭。
  • 如果操作系统功能正常，请按不到两秒钟的时间按开关以优雅的关闭为电源。
  • 如果操作系统不响应，请按电源开关超过4秒钟以强迫电源关闭。
• Two hot-swappable 100–240 VAC, 1000 W power supply modules. Max power consumption is 672 W. Typical power consumption is 540 W. Each power supply has an LED indicating its status as follows:

• Disable alarm button。当两个电源之一失去输入电源或电源故障时，按下此按钮以使电源警报保持沉默。
• Non-Maskable Interrupt (NMI) Button, used at the request of Technical Support to initiate a core dump. To press this red button, which is recessed to prevent unintentional activation, use a pen, pencil, or other pointed object. The NMI Button is also available remotely over the network in the LOM GUI, in the Remote Control menu. For more information, seeCitrix ADC SDX设备的灯光管理端口。