Configure an HTTP service

On the Citrix ADC appliance, a service represents a physical server on the network. In the transparent cache redirection configuration, the service represents the cache server. Cacheable requests are sent by the cache redirection virtual server to the load balancing virtual server, which in turn forwards each request to the correct service, which passes it on to the cache server.

Configure an HTTP service by using the CLI

At the command prompt, type the following commands to create an HTTP service and verify the configuration:

- add service     -cacheType  - show service [] 

Example:

> add service Service-HTTP-1 10.102.29.40 HTTP 80 -cacheType TRANSPARENT Done > show service Service-HTTP-1 Service-HTTP-1 (10.102.29.40:80) - HTTP State: DOWN Last state change was at Fri Jul 2 09:14:17 2010 Time since last state change: 0 days, 00:00:13.820 Server Name: 10.102.29.40 Server ID : 0 Monitor Threshold : 0 Max Conn: 0 Max Req: 0 Max Bandwidth: 0 kbits Use Source IP: NO Client Keepalive(CKA): NO Access Down Service: NO TCP Buffering(TCPB): NO HTTP Compression(CMP): YES Idle timeout: Client: 180 sec Server: 360 sec Client IP: DISABLED Cache Type: TRANSPARENT Redirect Mode: Cacheable: NO SC: OFF SP: ON Down state flush: ENABLED 1) Monitor Name: tcp-default State: DOWN Weight: 1 Probes: 3 Failed [Total: 3 Current: 3] Last response: Failure - Time out during TCP connection establishment stage Response Time: N/A Done 

Modify or remove a service by using the CLI

• To modify a service, use the set service command, which is just like using the add service command, except that you enter the name of an existing service.
• To remove a service, use therm servicecommand, which accepts only the argument.

Add an HTTP service by using the GUI

1. Navigate to Traffic Management > Load Balancing > Services

2. 在详细信息窗格中,单击Add。

3. In the Create Service dialog box, specify values for the following parameters as shown:

   • Service Name*—name
   • Server*— IP
   • Port*—port

   *A required parameter

4. In the Protocol* drop-down list, select a supported protocol (for example,HTTP).

5. 点击创建,then click Close.