Citrix ADC

VRRP interface binding in a single node active cluster

When you migrate a high availability (HA) setup to a cluster setup, all configurations must be compatible and must be supportable in the cluster. To achieve this, you can now configure virtual router IDs (VRIDs and VRID6s) on a node interface.

Important

目前,只有一个单节点活跃的集群系统m supports VRIDs and VRID6s.

For instructions for configuring VRIDs and VRID6s, seeConfiguring Virtual MAC Addresses.

To configure a virtual router ID on a single-node active cluster, add the VRID or VRID6 and bind it to the cluster-node interface.

To add a VRID by using the Citrix ADC CLI

At the command prompt, type:

add vrID 

To bind a VRID to the cluster-node interface by using the Citrix ADC CLI

At the command prompt, type:

Bind vrid  -ifnum  | -trackifNum 

To add a VRID6 by using the Citrix ADC CLI

At the command prompt, type:

add vrID6 

To bind a VRID6 to a cluster node interface by using the CLI

At the command prompt, type:

bind vrid6  -ifnum  | -trackifNum  Add vrID6 100 Bind vrid6 100 –ifnum 1/1 1/2 Done
VRRP interface binding in a single node active cluster

In this article