Configure the redirection mode

September 30, 2021

Contributed by:

C S

The redirection mode configures the method used by a virtual server to determine where to forward incoming traffic. The Citrix ADC appliance supports the following redirection modes. Before forwarding the request to a server, the redirection modes function as follows:

知识产权-Based forwarding (the default): The destination IP address is changed to the server’s IP address.
MAC-Based forwarding: The destination MAC address is changed to the server’s MAC address. However, the destination IP address is not changed. MAC-based redirection mode is used mostly in firewall load balancing deployments.
知识产权TUNNEL Based: An IP-in-IP encapsulation is performed for the client IP packets. In the outer IP headers, the destination IP address is set to the IP address of the server and the source IP address is set to the subnet IP (SNIP). The client IP packets are not modified. This is applicable to both IPv4 and IPv6 packets.
TOS ID Based: The virtual server’s TOS ID is encoded in the TOS field of the IP header.

You can use either the IP TUNNEL or the TOS option to implement Direct Server Return (DSR). For more information see:

You can configure MAC-Based forwarding on networks that use DSR topology, link load balancing, or firewall load balancing. For more information on MAC-Based forwarding for load balancing, seeConfigure MBF for load balancing configuration.

To configure the redirection mode by using the CLI

At the command prompt, type:

set lb vserver  -m

Example:

set lb vserver Vserver-LB-1 -m MAC

Note

For a service that is bound to a virtual server on which the-m MACoption is enabled, you must bind a non-user monitor.

To configure the redirection mode by using the GUI

Navigate toTraffic Management > Load Balancing > Virtual Servers.
Open a virtual server and select the redirection mode.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Configure the redirection mode

September 30, 2021

Contributed by:

C S

September 30, 2021

Contributed by:

C S

Configure the redirection mode

To configure the redirection mode by using the CLI

To configure the redirection mode by using the GUI

In this article