ADC

反对figure a backup route

当主为了防止中断服务route is down, you can configure a backup route. Once the backup route is configured, the Citrix ADC appliance automatically uses it when the primary route fails. First create a primary virtual server as described in反对figuring an LLB Virtual Server and Binding a Service. To configure a backup route, create a secondary virtual server similar to a primary virtual server and then designate this virtual server as a backup virtual server (route).

In the following diagram,Router-vipis the primary virtual server, andBackup_Router-vipis the secondary virtual server designated as the backup virtual server.

图1所示。备份路由设置

备份路由设置

Note:If your ISP has provided an IPv6 address, replace the IPv4 service with an IPv6 service in the preceding figure.

By default, all traffic is sent through the primary route. However, when the primary route fails, all traffic is diverted to the backup route as shown in the following diagram.

Figure 2. Back up Routing in Operation

Back up Routing in Operation

Note:If your ISP has provided an IPv6 address, replace the IPv4 service with an IPv6 service in the preceding figure.

To set the secondary virtual server as the backup virtual server by using the command line interface

At the command prompt, type:

set lb vserver  -backupVserver  

Example:

set lb vserver Router-vip -backupVServer Backup_Router-vip > show lb vserver Router-vip Router-vip (0.0.0.0:0) - ANY Type: ADDRESS State: UP Last state change was at Fri Sep 3 04:46:48 2010 Time since last state change: 0 days, 03:09:45.600 Effective State: UP Client Idle Timeout: 120 sec Down state flush: ENABLED Disable Primary Vserver On Down : DISABLED No. of Bound Services : 1 (Total) 1 (Active) Configured Method: ROUNDROBIN Mode: IP Persistence: DESTIP Persistence Mask: 255.255.255.255 Persistence v6MaskLength: 128 Persistence Timeout: 2 min Backup: Router2-vip Connection Failover: DISABLED Done 

To set the secondary virtual server as the backup virtual server by using the configuration utility

  1. Navigate toTraffic Management > Load Balancing > Virtual Serversand select the secondary virtual server for which you want to configure the backup virtual server.
  2. In theLoad Balancing Virtual Serverdialog box, under亿旺资讯公司ed, selectProtection.
  3. In theBackup Virtual Serverdrop-down list, select the secondary backup virtual server, and then clickOK.
反对figure a backup route