配置边缘米ode

When deployed at the edge of a network, the Citrix ADC appliance dynamically learns about the servers on that network. Edge mode enables the appliance to dynamically learn about up to 40,000 HTTP servers and proxy TCP connections for these servers.

This mode turns on the collection of statistics for the dynamically learned services and is typically used in transparent deployments for cache redirection.

Enable edge mode by using the CLI

At the command prompt, type the following commands to enable edge mode and verify the setting:

- enable ns mode Edge - show ns mode 

Example:

> enable ns mode edge Done > show ns mode Mode Acronym Status ------- ------- ------ ... ... ... 6) MAC-based forwarding MBF ON 7) Edge configuration Edge ON 8) Use Subnet IP USNIP OFF ... ... ... 16) Bridge BPDUs BridgeBPDUs OFF Done 

Enable edge mode by using the GUI

1. In the navigation pane, expand System, and then click Settings.
2. In the details pane, under Modes and Features, click Configure modes.
3. In Configure Modes dialog box, select the check box next to the Edge Configuration, and then click OK.
4. In Enable/Disable Feature(s)? dialog box, click Yes.