将DNS服务绑定to the virtual server

For the DNS server to respond to DNS requests, the service representing the DNS server must be bound to the DNS virtual server.

将DNS服务绑定to the load balancing virtual server by using the CLI

At the command prompt, type the following commands to bind the DNS service to the load balancing virtual server and verify the configuration:

- bind lb vserver   - show lb vserver  

Example:

> bind lb vserver Vserver-DNS-1 Service-DNS-1 Done > show lb vserver Vserver-DNS-1 Vserver-DNS-1 (0.0.0.0:0) - DNS Type: ADDRESS State: DOWN Last state change was at Fri Jul 2 10:32:28 2010 Time since last state change: 0 days, 00:12:16.80 Effective State: DOWN ARP:DISABLED Client Idle Timeout: 120 sec Down state flush: ENABLED Disable Primary Vserver On Down : DISABLED No. of Bound Services : 1 (Total) 0 (Active) Configured Method: LEASTCONNECTION Mode: IP Persistence: NONE 1) Service-DNS-1 (10.102.29.41: 53) - DNS State: DOWN Weight: 1 Done > 

Unbind a DNS service from the load balancing virtual server by using the CLI

Use theunbind lb vservercommand instead ofbind lb vserver.

Bind/Unbind a DNS service to/from a load balancing virtual server by using the GUI

1. Navigate to Traffic Management > Load Balancing > Virtual Servers
2. In the details pane, select the virtual server to/from which you want to bind/unbind the DNS service, and then click Open.
3. On the Services tab, in the Active column, select/clear the check box next to the Service Name.
4. Click OK.