ADC

Configure a load balancing method that does not include a policy

After you select a load balancing algorithm for your load balancing setup, you must configure the Citrix ADC appliance to use that algorithm. You can configure it by using the CLI or by using the configuration utility.

Note:

The token method is policy based and requires more configuration than is described here. To configure the token method, seeToken method.

For some hash-based methods, you can mask an IP address to direct requests belonging to the same subnet to the same server. For more information, seeHashing methods.

设置负载平衡method by using the command line interface

At the command prompt, type:

set lb vserver  -lbMethod  

Example:

set lb vserver Vserver-LB-1 -lbMethod LeastConnection 

设置负载平衡method by using the configuration utility

  1. Navigate toTrafficManagement>LoadBalancing>VirtualServers, and open a virtual server.
  2. In Advanced Settings, clickMethod, and in the Load Balancing Method list, select a method.
Configure a load balancing method that does not include a policy